Hictop CR10-S bed adhesion

By Catelyn | May 21, 2019

Is the temp too high? Is the nozzle clogged? Maybe the bed isn’t perfectly level? Nope, it’s the z-offset It is ALWAYS the z-offset. (it’s ok, I didn’t need those three hours for anything)

Read More

3D Printer Running

By Catelyn | February 8, 2019

I got FABRIC’s 3D printer put together and running months ago, but as it’s a CR-10S, the printing bed had to be re-calibrated BY HAND after every print! That was awful. I bought an auto-calibration sensor kit from TH3Dstudio.com (with my own money!) almost 6 months ago, and finally got that set up this week.…

Read More